|
Armature
Inspection/Balancing Services
Looking to build a VHORS SS or
Fray Race Car. You send me your favorite Aurora Factory Stock Armatures
and I will perform the following services for you to maximize performance out of
your motor:
-
Visual Inspection: I visually inspect the armature for any
obvious flaws that would impede it's performance.
-
Electrical Checks: Measure for uniform resistance (ohms) across all
armature poles and test for electrical shorts.
-
Shaft Inspection/Polishing: Measure the shaft for straightness, adjust if necessary, and polish
it.
-
Commutator Plate Truing: Measure the commutator plate for perpendicularity
(run-out) to the shaft,
adjust if necessary, and polish it.
-
Stack Truing:
True the pole faces
(stacks) for concentricity to the shaft, and even air gaps between magnets.
(Note: this is done on a lathe for precision turning, not a Dremel Tool.)
-
Epoxy Balancing: Balance the armature with Epoxy.
NOTE: I do not
balance by removing material from the pole faces. I epoxy balance only.
Maximum
Performance Package Price - $6.00
Shipping is always free.
|
